Driver Bug Fixes:
-----------------
1. WSW-19892: Driver compilation errors on older kernel version
2. WSW-19638: Enable RF Test Mode support for 9098 PCIE and SDIO
3. WCSWREL-370: oob irq request fail on i.MX93 9x9 qsb board
4. WSW-21756: WLAN Driver hang observed during WiFi connect/disconnect
5. WCSWREL-362: merge the L6.0.0 build errors fix patches
6. WSW-22054: STA CSA event is not propagated to cfg80211
7. WSW-21873: STA does not send probes after switching from DFS channel
8. WSW-21530: UDP Tx not able to send ARP when high bandwidth is used
9. WSW-21541: WFA Pre-Cert Channel switch test is failing
10. WSW-21072: AP stops sending CTS-to-Self in mcast Tx after issue mc_aggr_cfg
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Driver Bug Fixes:
-----------------
1. LF-6972: Updated the License to GPL-2.0
2. Incremented the driver version
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Driver Bug Fixes:
-----------------
1. Added GPL/NXP dual license header
2. WCSWREL-242: Fixed system rebooted issue after connecting wifi and running bt A2DP stress
3. WCSWREL-310: merge the L5.17 build errors and warnings related to netif_rx
4. WCSWREL-317: merge the build error and warning fix related to eth_hw_addr_set
5. WSW-19664: Fixed VtsHalWifiV1_0TargetTest failure
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
changes:
1. WCSWREL-199: Fixed the build error on kernel higher than L5.12
2. WSW-16639: Improve the throughput by avoiding skb copy in amsdu deaggreation
3. WSW-15903: By default enabled pmqos=1 module param on IMX8 only and disable this for other platforms like X86
4. WSFD-411: Generate fw_dump files in HAL layer instead of driver
5. WSW-17154: Fixed the issue of driver crash seen with AGO+AGO restart stress test
6. WSFD-416: Added WPA3 R3 support using embedded supplicant
7. WSW-16171: Fixed the issue of DUT failed to roam to other AP2, when low RSSI hits on connected AP1
8. WSW-17323: Fixed the issue of not activating Channel 13 using DE or JP country codes
9. WSW-16630: APUT is not switching back from 20/40MHz to 20MHz channel bandwidth in the presence of 20MHz testbed AP
10. WCECCB-37: Added support for UNII-4 / upper 5 GHz channels
11. WSW-17368: Fixed the issue of System shutdown after switching AC power to battery
12. WSW-17447: Added RTT support enablement for Android
13. WSW-17453: Fixed the issue of 0x107 Command timeout for scan(iwlist)
14. WSW-17019: Fixed the issue of Wifi hang with timeout cmd id 0x20 due to interference from another device doing DPD
15. WSW-14: Added Support for IMX Linux Kernel 5.15.0
16. WSW-17450: Disable host based Link layer stats so that fw based stats will be used
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Approved-by: Tian Yang <yang.tian@nxp.com>
changes:
1. WCSWREL-191: Fixed the error when loading module param from user config for SD8801
2. WCSWREL-186: Fixed the issue of mlanutl failing on kernel higher than L5.15
3. Fixed low throughput issue for WPA3 SAE
4. Added driver change for WLAN throughput improvement on 8997 SoC
5. Updated README to recommend not to use WEP/TKIP for all chipsets
6. WCSWREL-180: Fix P2P test fail on kernel higher than L5.12
7. WCSWREL-156: kernel_write/kernel_read not allowed by drivers for L5.10 kernel GKI buildou
8. Alternative for pm_qos_add_request/pm_qos_remove_request
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Approved-by: Tian Yang <yang.tian@nxp.com>
changes:
1. Added support for PCIE-UART W9098 SoC
2. Added support for SDIO-UART W8997 SoC
3. Added a new RF Test Mode command
4. Added txratecfg and 11axcfg related commands to mlanutl light to
support pre-cert testing
5. Added cpu_latency_qos_add/remove_request calls for L5.10 for better
CPU performance during throughput tests
6. Added fixes for MBO Pre-Cert failure
7. Fixed Copyright header start date, end date
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Reviewed-by: yang.tian <yang.tian@nxp.com>
changes:
1. Added support for IMX Linux Kernel version 5.10
2. LF 5.10 need to be build out of tree
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Reviewed-by: yang.tian <yang.tian@nxp.com>
