Driver Bug Fixes:
-----------------
1. WSW-19892: Driver compilation errors on older kernel version
2. WSW-19638: Enable RF Test Mode support for 9098 PCIE and SDIO
3. WCSWREL-370: oob irq request fail on i.MX93 9x9 qsb board
4. WSW-21756: WLAN Driver hang observed during WiFi connect/disconnect
5. WCSWREL-362: merge the L6.0.0 build errors fix patches
6. WSW-22054: STA CSA event is not propagated to cfg80211
7. WSW-21873: STA does not send probes after switching from DFS channel
8. WSW-21530: UDP Tx not able to send ARP when high bandwidth is used
9. WSW-21541: WFA Pre-Cert Channel switch test is failing
10. WSW-21072: AP stops sending CTS-to-Self in mcast Tx after issue mc_aggr_cfg
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Driver Bug Fixes:
-----------------
1. LF-6972: Updated the License to GPL-2.0
2. Incremented the driver version
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Driver Bug Fixes:
-----------------
1. WCSWREL-352: Fixed WiFi driver kernel panic with "use after free" print
2. WCSWREL-353: Fixed WiFi driver panic when switch AP to another AP
3. WCSWREL-337: merge the L5.18 build errors and warnings fix patches into next wifi release
4. WSW-16518: Fixed STA going to unresponsive state during basic UAPSD operation
5. WSW-19350: Observed "unexpected kernel BRK exception" in STA 2G VHT with BT HID traffic running simultaneously
6. WSW-19640: cannot enable the "20/40 BSS Coexistence Management" support
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Driver Bug Fixes:
-----------------
1. Added GPL/NXP dual license header
2. WCSWREL-242: Fixed system rebooted issue after connecting wifi and running bt A2DP stress
3. WCSWREL-310: merge the L5.17 build errors and warnings related to netif_rx
4. WCSWREL-317: merge the build error and warning fix related to eth_hw_addr_set
5. WSW-19664: Fixed VtsHalWifiV1_0TargetTest failure
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
New Additions/Removals/Improvements:
------------------------------------
1. WSW-18868: Improve FW download time after suspend/resume cycle
2. WSFD-484: WIFI 6E support
3. WSW-17954: Enable turbo mode command for mlanutl
4. WSW-19363: Add debug prints to WLAN driver regarding WPA_supplicant
5. WSW-19307: Support robust btc related commands [0x00e0] in mlanutl
6. WSW-16429: Disabling of WEP/TKIP on all V16 devices
7. Use CFG80211_VERSION_CODE to control cfg80211 related code
8. Enabled these new commands for mlanutl: min_ba_threshold, stop_su and ed_mac_ctrl_v3
9. WSFD-386: FW and VHAL Implementation for WOWLAN by adding code for MDNS wakeup
Driver Bug Fixes:
-----------------
1. WSW-18708: Setting domain info fails for W8801 Murata M.2 Module (2DS)
2. WSW-18541: Debug logs not seen if drvdbg is part of wifi_mod_para.conf
3. WSW-19136: Command 0x107 timeout is seen radomly during connect-disconnect test
4. WSW-18865: VHT80 TCP-tx throughput only run about 170Mbps, both STA and MMH mode
5. WSW-17923: 4K Video Stoppage Issue, Wi-Fi throughput drops to lower than 20Mbps without recovery
6. WSW-17925: NO_IR flags are not cleared for ch 12,13 and 14 if country is changed to JP in runtime
7. WCSWREL-251: There is "mlan0: Failed to initialize driver interface" during stress load/unload testing
8. WSW-18431: UAP beacon (in 1x1 mode) not reporting correct values for tx_highest_rate and rx_highest_rate in VhtCap IE
9. WSW-18116: TCP Keep alive packets are not seen after starting cloud keep alive
10. WSW-18690: STAUT is advertising support of MCS-0 to 9 only in HE-IE in Probe Request
11. WCSWREL-266: Fix L5.16 build errors and warnings
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
changes:
1. WCSWREL-191: Fixed the error when loading module param from user config for SD8801
2. WCSWREL-186: Fixed the issue of mlanutl failing on kernel higher than L5.15
3. Fixed low throughput issue for WPA3 SAE
4. Added driver change for WLAN throughput improvement on 8997 SoC
5. Updated README to recommend not to use WEP/TKIP for all chipsets
6. WCSWREL-180: Fix P2P test fail on kernel higher than L5.12
7. WCSWREL-156: kernel_write/kernel_read not allowed by drivers for L5.10 kernel GKI buildou
8. Alternative for pm_qos_add_request/pm_qos_remove_request
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Approved-by: Tian Yang <yang.tian@nxp.com>
When use mlanutl on L5.15, will meet below error logs:
root@imx8mqevk:/usr/share/nxp_wireless# ./mlanutl mlan0 hssetpara 2 0xff 0xc8 3 400
mlanutl: Operation not supported
mlanutl: hssetpara fail
This is due to the net common api change the ndo_do_ioctl behavior, it
splits out all the users of SIOCDEVPRIVATE ioctls into a separate
ndo_siocdevprivate callback. All the ioctl functions through
SIOCDEVPRIVATE in mlanutl.c will fail if not follow this upstream api
change. So here change to use new ndo_siocdevprivate instead of
ndo_do_ioctl on L5.15.
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Approved-by: Tian Yang <yang.tian@nxp.com>
changes:
1. Added support for PCIE-UART W9098 SoC
2. Added support for SDIO-UART W8997 SoC
3. Added a new RF Test Mode command
4. Added txratecfg and 11axcfg related commands to mlanutl light to
support pre-cert testing
5. Added cpu_latency_qos_add/remove_request calls for L5.10 for better
CPU performance during throughput tests
6. Added fixes for MBO Pre-Cert failure
7. Fixed Copyright header start date, end date
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Reviewed-by: yang.tian <yang.tian@nxp.com>
changes:
1. Added support for IMX Linux Kernel version 5.10
2. LF 5.10 need to be build out of tree
Signed-off-by: Sherry Sun <sherry.sun@nxp.com>
Reviewed-by: yang.tian <yang.tian@nxp.com>
